Building a 16 Ton Hydraulic FORGING PRESS
This video documents my journey building a 16 Ton Hydraulic Forging press. My press was constructed with 1 inch plate, 3/8 inch angle iron, and 1/4 inch square tubing. I used an oxy propane cutting torch to cut out the pieces. This is a 220 volt machine. It runs off a 5 hp electric motor that turns a 2 stage, 11 gallon per minute hydraulic pump. The force is applied by a hydraulic cylinder with a 4 inch bore and 10 inch stroke length. The system pressure is capped at about 2,550PSI by the hydraulic valve. Thanks for watching. www.leshanesteel.com IG: LeShane_Knife_and_Steel
▶︎
DIY 30 Ton Hydraulic Forge Press Part 1
▶︎
Making a log splitter forging press
▶︎
Massive Net Fishing! Smoking & Marinating Fresh Fish - صيد ضخم بالشباك! تدخين وتتبيل الأسماك الطازجة
▶︎
The Clark Iron 25 Ton Forging Press
▶︎
Pressing Concerns - Hydraulic forging press modifications
▶︎
Can This Smashed Track Motor Run Again? Genius Girl's Hardcore Salvage
▶︎
Hydraulic Forging Press Build
▶︎
DIY 30 Ton Hydraulic Forge Press Part 3
▶︎
Building a 24 Ton Log-Splitter Forging Press!
▶︎
Hydraulic press build - FORGING PRESS
▶︎
Building af 10 ton hydraulic forge press
▶︎
Making super light, resolvable 25 TON forging press: full guide
▶︎
Draining a Wild Pond | Catching a Giant 10KG Turtle & Lots of Big Fish for the Village Market
▶︎
Homemade Hydraulic FORGING Press - EXTREME POWER!! 💪
▶︎
Knife Making - Hydraulic Press for knife Maker
▶︎
Custom forging press finished
▶︎
Building a big forge press for blacksmithing
▶︎
Electric Forging Press "Log Splitter Press"
▶︎
From Raw Materials to Powerhouse: Building a Forging Press from Scratch!
▶︎