Almost a DISASTER | Dovetail Jewelry Box Build

This jewelry box took me 80 hours to build and contains 64 hand cut mitered, half-blind, and through dovetails. All dovetail joinery is cut completely by hand, and much of the other joinery is hand cut as well. I built it for my wife for Valentines day. During the glue up of this box, I accidentally assembled the carcass in the wrong order, leaving me with a pin board as the fourth piece. While frantically trying to disassemble the quickly-drying glue joints, I snapped the side wall of this box in half along the grain. I had spent two weeks working up to this point. Thanks to some quick thinking I was able to perfectly repair the joint. In the final box, the broken seam is 100% completely invisible. The outer carcass is made of one piece of solid walnut, with mitered dovetails visible from the front and back for a more modern look. The back panel is also solid walnut from the same log, and it floats in a groove. It is only glued in the central points to allow for expansion and contraction. The drawer dividers are walnut and fit in dados cut on the router table. The drawers have continuous grain walnut fronts with half blind dovetails. The drawer sides are maple, the backs are cherry, and the bottoms are maple veneered plywood. The custom drawer dividers are made of walnut and can be removed. The two vertical drawers house 20 necklaces (5 on each side of each drawer, as the bottom panel actually fits in the middle of the drawer). The necklaces hang on grooved walnut dowels coated with a rubberized substance to give more grip. The bottom of the necklaces pool in custom walnut slots. The drawer stops are made of maple and fit into stopped holes made with two different sized forstener bits. They are of course removable if the drawers ever need to be removed. Every surface is finished with multiple coats of spray lacquer, buffed to a glass smooth finish. The hardware is brass and is all made by Brusso. The feet are item "JB-755" (https://www.brusso.com/jb-755-box-feet/) and the knobs are item "MC-428" (https://www.brusso.com/mc-428/). The dimensions of the box are as follows: 10" wide, 7" tall, 6 3/4" deep. Outer walls 7/16" thick. Drawer dividers 1/4" thick. Vertical drawers 1 1/2" wide. Horizontal drawers 1 1/4" tall. Drawer fronts 1/2" thick. Drawer sides 1/4" thick. Thanks for watching. Feel free to leave a comment with your thoughts, and don't forget to subscribe if you like content like this! ** Want to buy the tools and accessories I use in my videos? Here is my Amazon affiliate store where you can get them for yourself! https://www.amazon.com/shop/dkbuilds -------------- Support me on Patreon here:   / dkbuilds   Check out my instagram page here:   / dkbuilds   Or my facebook page here:   / dkbuilds   Or my Etsy shop here: https://www.etsy.com/shop/DKBuildsWoo... -------------- #dkbuilds #jewelrybox #finewoodworking