CAST IRON ROLLER FOR CANE MILL
This is the large cane mill roller that was cast for Keith Rucker @VintageMachinery This was the most complicated, exhausting, and limit pushing mold that we have made and it's because of this that this video runs over 2 hours long. The longest video I have ever posted actually and keep in mind a lot of footage was removed. With that said, the speed of this video is sped up 20% to avoid a 3 hour video. PS: I may have removed all the drama https://www.patreon.com/windyhillfoun...
▶︎
10 Years Later- The TRUTH about helical jointer/planer cutterheads
▶︎
More RUST!? - Making a Panel & PLAN - 1939 Lincoln Zephyr 3W Conversion
▶︎
FINIALS FOR OLD STATE HOUSE OF ARKANSAS
▶︎
Gold Filled Ink Pens ARE VALUABLE
▶︎
How One Sherman Crew Killed Wittmann — The Tank Ace Hitler Couldn't Replace
▶︎
Over 500ft Deep, How Much Water did it Make? Is it Clean Water? Lets find out!
▶︎
Magnets Aren't Always Right!
▶︎
THIS & THAT #91 tubalcain
▶︎
Vulcan Steam Locomotive Repairs - Making New Main Rod Front Bronze Bearings
▶︎
Beginner's Guide To Surface Plates
▶︎
How did they make this in the 1800's?!
▶︎
FIRST ATTEMPT TO CAST VULCAN LOCOMOTIVE PISTONS
▶︎
Re-Restoring The Steam Hammer! Part 11
▶︎
The Wrecker Needs This... I Haven't Done This In Years!
▶︎
Milling Gold Bars??? That Ain’t Gold! Planing Long Bronze Bars on a Custom Planer Mill
▶︎
I FINALLY Have A Rotator In My Yard! (and it's red!)
▶︎
POURING IRON WITH PRECISION
▶︎
Honda Grom Wheel Machined in the American Pacemaker
▶︎
How We Thread 30ft Drill Rods (Wild Megabore Setup!)
▶︎