Engraver.com Sharpening System - Part 1 - 90 Degree Graver

Tira Mitchell introduces Engraver.com's new Sharpening System. Developped in cooperation with Joacim Jansson, this system is an inexpensive way to make gravers quickly and consistently. Using a series of blocks, insert gravers into holes drilled at specific angles to create, sharpen and polish parallel heeled gravers. 90 degree and 105 degree blocks are currently available. Create faces of 45, 55 or 60 degrees. Fix the faces of pre-shaped gravers. Add exact heels to flats. Use with a hone or Engraver.com's 5 Inch Diamond Disk Holder. Links: Double Deluxe Block Set - https://www.engraver.com/double-delux... Double Block Set - https://www.engraver.com/double-block... Face Fixer Set - https://www.engraver.com/face-fixer-e... 90 Degree Parallel Heel Graver Set - https://www.engraver.com/90-degree-en... 105 Degree Parallel Heel Graver Set - https://www.engraver.com/105-degree-e... Individual Graver Blocks - https://www.engraver.com/engraver-com... Chapters: 00:00 Introduction 00:07 Sharpening System Components 00:41 Collets and Gravers 01:47 Grinding your Face Angle 05:58 Creating a 90 Degree Graver 11:44 Adding Heels to a 90 Degree Graver 15:29 Block Design - Parallel heels with 55 Face 15:29 55 Degree Face is needed for Parallel Heels 16:08 No Hone? No Problem! 17:02 Sharpening a Pre Shaped Graver's Face with a 60 Degree Face Block 17:58 Sharpening a Flat Graver's Heels