DIY 3DOF MOTION NEW SERIES GET YOUR DIY MOTION SIMULATOR UP AND RUNNING EPISODE 1 - COMPONENT BOX

NEW SERIES - Yes finally we are going to get the compact motion simulator up and running. the first thing we need to do is build t component box to house the arduino, the 3 IBT motor controllers, the power rail and the wiring distribution. 00:00 start 05:00 modifying the component box 10:00 fitting arudino, IBT-2 and wire distribution panel into place MUSIC provided by You Tube content free music ----- EMAIL ME at - [email protected] ____ Tie rod ends : https://www.amazon.com/dp/B00ELO68CK?... 50:1 12volt motors just search Ebay for GEAR MOTOR 12 VOLT GREAT FOR SAWMILL/CRAB POT PULL/FEED/SIMULATOR 75-80RPM 50:1 (sold by PGSAW in Canada) Hall Effect Potentiometers DIGI-Key and others PN 987-1392-ND https://www.digikey.co.uk/en/products... Arduino UNO R3 - amazon. I have also used the cheaper ELEGOO clone. https://www.amazon.com/Arduino-A00006... IBT-2 motor controllers up to 43amps (which is a lot!) https://www.amazon.com/dp/B00WSN98DC?... other motor controllers you could consider using are JRK12V12 or Sabertooth but I use IBT-2's XSIMULATOR forum - Info specifically for arduino/IBT-2 for 1 to 3 Motors. You can use up to three motors per arduino. But you each motor needs it's own IBT-2 controller. https://www.xsimulator.net/community/... DMAX motion sim build posts on XSimulator https://www.xsimulator.net/community/...