wiring up your DIY motion simulator - arduino - IBT-2 - 3 DOF motion sim -

This video is demonstrates how to begin wiring up your DIY motion simulator - the electronic components - the aruduino uno, the IBT-2 motor controllers, the hall effect sensors.. I'm just showing you how I do this and what problems you may encounter.. It's a bit of a long video for me but if you really are interested in DIY motion simulators, like this 3DOF DIY motion simulator I showed how to make in the "compact" motion simulator series, then this video is for you.. please comment as I do attempt to cover even the most basic soldering, what to order, how to do it etc.. MUSIC provided by You Tube content free music ----- EMAIL ME at - [email protected] ____ Tie rod ends : https://www.amazon.com/dp/B00ELO68CK?... 50:1 12volt motors just search Ebay for GEAR MOTOR 12 VOLT GREAT FOR SAWMILL/CRAB POT PULL/FEED/SIMULATOR 75-80RPM 50:1 (sold by PGSAW in Canada) Hall Effect Potentiometers DIGI-Key and others PN 987-1392-ND https://www.digikey.co.uk/en/products... Arduino UNO R3 - amazon. I have also used the cheaper ELEGOO clone. https://www.amazon.com/Arduino-A00006... IBT-2 motor controllers up to 43amps (which is a lot!) https://www.amazon.com/dp/B00WSN98DC?... other motor controllers you could consider using are JRK12V12 or Sabertooth but I use IBT-2's XSIMULATOR forum - Info specifically for arduino/IBT-2 for 1 to 3 Motors. You can use up to three motors per arduino. But you each motor needs it's own IBT-2 controller. https://www.xsimulator.net/community/... DMAX motion sim build posts on XSimulator https://www.xsimulator.net/community/...