The SY2-D surge protector (SPD)
Surge protection made easy for 18th Edition! Also available in (sober) article form at: https://www.dses.co.uk/index.php/free... Device kindly supplied to me by Surge Protection Devices Ltd. following my approach to them after seeing their stand at Elex 2018. This is not a paid promotion. Note that the graphic showing the connection of this device around the 14 minute mark is technically incorrect - it should show the main switch connected to the top of the RCD, then the MCB connected to the bottom. A corrected graphic can be seen on my website. Related videos: My install of a Type-2 unit on site: • Exciting new SPD installation - with cock-up! How I ballsed-up the above install: • Surge protection - a correction!
▶︎
Surge protection - a correction!
▶︎
Inside a 13,500A surge protector. (With schematic.)
▶︎
Surge Protection Devices - Part 1
▶︎
EICR failure site - righting the wrongs
▶︎
Why do Surge Protection Devices no longer require an MCB?
▶︎
When Safe Isolation Isn't Enough - Deadly Diverted Neutral Current
▶︎
How To Install a Surge Protector in Main Panel - Best SPD Location & NEC Type 1, 2, 3, & 4 Explained
▶︎
Avoid Nuisance Tripping - Converting a dual RCD consumer unit to an RCBO one. Schneider EZ9.
▶︎
My Consumer Unit Secrets 🤫 How to Install a Consumer Unit/Fuse Box in 2026
▶︎
BS 7671 Amendment 4: What Every Electrician Must Know!
▶︎
Apparently its easy to install a consumer unit ??? Full run through - TIPS - TRICKS - BAD HABITS???
▶︎
Surge Protection Devices - Part 2
▶︎
How to wire a type 2 surge arrester into a distribution board - factors to consider - South Africa
▶︎
RCBO installation - Upgrade
▶︎
Safe isolation procedure
▶︎
How 3 Phase Power works: why 3 phases?
▶︎
Why German Engineers Couldn't Explain How Britain Built A Bomb That Bounced On Water
▶︎
The single mod SPD they didn’t tell us about!!!
▶︎
EICR FAIL- Maximum demand
▶︎