How to dismantle and assemble Grundfos SE1, SEV pumps without sensor

See how a Grundfos service specialist dismantle and assemble Grundfos SE1, SEV pumps without sensor and find out what the job requires and how it is performed. The different sections include: 00:00 Introduction Dismantling: 00:14 Removing the cable 00:38 Removing the pump housing 01:09 Drainage of oil 01:55 Removing the impeller 02:29 Removing shaft seal 04:36 Remove the shaft with rotor and bearings 06:27 Removing the stator and housing 09:55 Removing the moisture switch and water-in-oil sensor(WIO) Assembly: 11:08 Fitting the moisture switch and water-in-oil sensor(WIO) 13:39 Fitting of stator housing 17:28 Fitting of shaft with rotor and bearings 19:05 Fitting of shaft seal 21:00 Filling of oil 21:33 Fitting of impeller 22:16 Mounting of pump housing 23:22 Fitting the cable 32:06 Replacement of stator Learn more about SE, spare parts, service kits and additional services and solutions provided by Grundfos on https://product-selection.grundfos.co... and do not hesitate to contact us via http: http://www.grundfos.com/pleasecallus. DISCLAIMER This service video provides “how to” guidance for Grundfos products and is aimed only at skilled, trained personnel. N.B. Any stricter local health and safety regulations and requirements take precedence over this guidance. The video and any information in it is provided on an “as is” basis and without any liability and/or warranty to the extent permitted by applicable law. Grundfos reviews and updates the information provided on a regular basis. However, instructions may have changed since publication of this video and therefore please always check the latest Service Instructions and the Installation & Operating Instructions of the related product. These documents can be found on https://product-selection.grundfos.co.... #pumpservice #pumprepair #grundfospumps #grundfosservice