How to dismantle and assemble Grundfos SE1, SEV pump with sensor

See how a Grundfos service specialist repair ceramic coating on Grundfos NB, NK or TP pump and find out what the job requires and how it is performed. The different sections include: 00:00 Introduction Dismantling: 00:13 Removing the cable 00:35 Removing the pump housing 01:07 Drainage of oil 01:57 Removing the impeller 02:30 Removing the shaft seal 04:34 Removing shaft with rotor and bearings 06:27 Removing the stator housing 09:54 Removing the moisture switch and WIO sensor Assembly: 10:06 Fitting the moisture switch and WIO sensor 13:39 Fitting the stator housing 17:29 Fitting the shaft with rotor and bearings 19:05 Fitting the shaft seal 20:57 Filling of oil 21:35 Fitting the impeller 22:16 Mounting the pump housing 23:20 Fitting the cable Learn more about SE, spare parts, service kits and additional services and solutions provided by Grundfos on https://product-selection.grundfos.co... and do not hesitate to contact us via http://www.grundfos.com/pleasecallus. DISCLAIMER This service video provides “how to” guidance for Grundfos products and is aimed only at skilled, trained personnel. N.B. Any stricter local health and safety regulations and requirements take precedence over this guidance. The video and any information in it is provided on an “as is” basis and without any liability and/or warranty to the extent permitted by applicable law. Grundfos reviews and updates the information provided on a regular basis. However, instructions may have changed since publication of this video and therefore please always check the latest Service Instructions and the Installation & Operating Instructions of the related product. These documents can be found on https://product-selection.grundfos.co... #pumpservice #pumprepair #grundfospumps #grundfosservice