E-Step Calibration Voxelab Aquila

Using the Voxelab Aquila, two separate ways to calibrate e-steps. Then tune the flow percentage to make sure the nozzle is also putting out the proper amount of filament. You do not need to use both calibration methods, pick whichever you prefer and get your machine tuned up and printing accurately. Addendum: I should note the calipers I use in this video are only accurate up to 0.1mm. so when using my calipers a reading of 0.81 and 0.87 will both read on my calipers as "0.8". This makes my calipers not wholly accurate, as there could be a large deviation I am not accounting for. It has, however, been my experience that while these calipers aren't accurate to a hundredth of a mm they still provide me with accurate enough results that I feel confident this process is providing me with better prints. This whole reevaluation of my methods has made me consider upgrading to a more accurate (yet still inexpensive) pair, and I thank @AlexeySychev for that, as this is the user who pointed out this inaccuracy. So if your callipers, like mine, are only accurate to a tenth of a mm I still recommend using them for these calibrations, some calibration is better than none. However if you are in the market for a set of calipers and plan on performing these calibrations (which you should!) Then I recommend searching for calipers that can read up to at least a hundredth of a millimeter (0.01). This is the newest set of calipers I purchased from Harbor Freight https://www.harborfreight.com/6-in-di... °°°Join the Discord °°°°   / discord   Check out some beginner articles and support the Channel! Printsleo3d.com ***Buy Me a Coffee (not necessary but certainly appreciated!)*** **********https://www.buymeacoffee.com/PrintsLe... Note: As an Amazon Associate, I earn from qualifying purchases. *3D Printer* Voxelab Aquila : https://amzn.to/3glCsDm *Music* Intro : Bomber (sting) - Riot *Models* Extruder Knob - https://www.thingiverse.com/thing:317... Iron-Man(intro) - original design - javisanz : https://www.thingiverse.com/thing:396... unsupported design - iczfirz : https://www.thingiverse.com/thing:460... Calibration Cube - https://www.thingiverse.com/thing:483... *More Content* Website: Printsleo3d.com Instagram: @PrintsLeo3D Twitter: @PrintsLeo3D Etsy: https://www.etsy.com/shop/PrintsLeo3D Thingiverse : https://www.thingiverse.com/printsleo...