WW1 Sword Bayonet Restoration, pattern 1907 (Mark I)

The Pattern 1907 bayonet consisted of a one-piece steel blade and tang, with a crossguard and pommel made from wrought iron or mild steel, and a wooden grip usually of walnut secured to the tang by two screws. The entire bayonet was 21 3⁄4 inches (550 mm) long and weighed 16 1⁄2 ounces (470 g), although the weight of production models varied from 16 to 18 ounces (450 to 510 g). Originally the bayonet featured a hooked lower quillion, intended to be used to trap and snap enemy bayonets when grappling, this was later deemed impractical and replaced with a simpler design from 1913, often unit armourers subsequently removed the hooked quillion when the bayonet went for repair, although there is no evidence that this was officially directed. The Pattern 1907 bayonet's blade was 17 inches (430 mm) long, it had a shallow fuller that was machined into both sides of the blade to save weight and add strength, the fuller was 12 inches (300 mm) long that extended to within 3 inches (76 mm) of the tip.[2][3] Original hooked quillion of the Pattern 1907 bayonet. The Pattern 1907 bayonet was supplied with a simple leather scabbard flitted with a steel top-mount and chape, it was usually carried from the belt by a simple frog. The Pattern 1907 bayonet attached to the SMLE by a boss located below the barrel on the nose of the rifle and a mortise groove on the pommel of the bayonet. The combined length of the SMLE and Pattern 1907 bayonet was 5 feet 2 inches Mr Cool is the best! Check out the Minisplit here! https://www.youtube.com/results?searc... https://amzn.to/2ZaXhKH https://amzn.to/3hz8qLn #MRCOOL #minisplit https://mrcool.com/diy-3rd-generation... #restoration #restored #ww1history