How to set up Diff Pinion Shaft Bearings for a Land Rover Series 2 in under 15 minutes!
Using the land rover series 2 diff as an example I show the viewer how to measure the pinion height so that the pinion gear will mesh with the crown wheel correctly using slip gauges and a ground steel bar. I then explain and demonstrate the whole process I use to set up the pinion shaft pre load on the Rover diff Pinion bearings. ----Contents:---- 00:00 Intro 00:12 How to measure pinion height 03:26 How to setup pinion shaft preload
▶︎
Land Rover Diff Overhaul - Finally, Setting Up the Backlash, Zero End Float and meshing test.
▶︎
Land Rover Diff Overhaul, How to Remove Bearings on the Final Drive.
▶︎
Contact Patch & Pinion Depth Explained
▶︎
Rebuilding a Land Rover Series 2 Front Axle Swivel Housing and Steering Joint (Part 2?) Restoration
▶︎
Land Rover Restoration Part 2 - Gearbox 1/2
▶︎
Land Rover Differential Overhaul - Necessary Pinion Setting Maths - Nominal Pinion Height
▶︎
Land Rover Diff Overhaul - Pinion Bearing Preload Shims, Crown Wheel Mounting and Bearing fitting
▶︎
Land Rover Restoration Part 3 - Gearbox 2/2
▶︎
The 90-Degree Torque Problem
▶︎
Land Rover Series Gearbox Rebuild Part 1
▶︎
REBUILDING A SWIVEL HOUSING: Part 1, Land Rover Series 2 Restoration
▶︎
How to replace worn propshaft universal joints on most Land Rovers using a Britpart kit
▶︎
Greasing Land Rover Propshafts. Some tips to make the job easier.
▶︎
Fitting Springs, Shackles and the Rear Axle to my Land Rover Series 2 Restoration
▶︎
Land Rover Series 2A diff (differential) restoration Electric Landrover Conversion
▶︎
Land Rover Restoration Part 10 - Front & Rear Axles 1/2
▶︎
1961 Series II Land Rover - Rear Pinion Seal Replacement
▶︎
Land Rover Restoration Part 11 - Front & Rear Axles 2/2
▶︎
Differential Build At Ashcroft Transmissions
▶︎