Installing a Tail Light into an Aston Martin DB9

I needed to reinstall the tail light assembly in my 2005 Aston Martin DB9 after removing it so I could route some wires for a rear parking camera. I was keen to install it properly with the correct panel gaps and sealed up water tight back to the car. I show you how to reconnect the electrical and to use the adjusters to get the fitment right. The process only takes a few minutes. You might have your tail light out for other reasons like having it repaired or changing to a new light unit that has clear lenses. Either way the process is the same. This process I think applies to many of the Gaydon era cars like the DB9, DBS, Virage and Vanquish. How to remove the tail light -    • Removing the Tail Lights from an Aston Mar...   Installing a Rear Parking Camera -    • Installing a Rear Parking Camera in an Ast...   Foam sealing gaskets - https://www.scuderiacarparts.com/part... More information can be found on my companion blog at http://www.Aston1936.com 0:00 Introduction 1:16 Paint Protection 1:43 Tools 2:05 Electrical Connection 3:05 Adjusting the Fitment 7:18 Sealing washers and Nuts 10:04 Final Fettling 11:26 Wrapping Up #aston1936 #AstonMartin #V12 #DB9 #Vantage #DBS #Rapide #Virage #Vanquish #astonmartindb9 #astonmartinv12 #astonmartinvantage #astonmartindbs #astonmartinvanquish