Teil 3: Hochwertige #Fußbodenheizung nachrüsten. #Dichtheitsprüfung selbst durchführen!

Part 1:    • Teil 1: Hochwertige #Fußbodenheizung nachr...   Part 2:    • Teil 2: Hochwertige #Fußbodenheizung nachr...   Part 4:    • Teil 4: Hochwertige #Fußbodenheizung nachr...   Affiliate links to the building materials and tools shown in the video (I earn a small commission when you purchase through these links, thus supporting my YouTube channel): Compressor: https://amzn.to/4ameVNq or https://amzn.to/3RIk37k in a set Digital pressure gauge 200 mBar: https://amzn.to/48gWXtS Pressure gauge 10 Bar: see https://amzn.to/3RiekUg Underfloor heating system: Blanke Permatop 1000 Blanke Permat: https://amzn.to/4a3Q1Sw Heating circuit manifold, self-balancing: https://amzn.to/3RkJ2Ml Eurocone fittings: https://amzn.to/3TgS4wH Smart Watch: https://amzn.to/3Q7tM4z In this video, I show you how I installed my underfloor heating myself. In my old building, installation height was important, so I used the screed-free system from Blanke. It consists of EPS insulation with glued-on aluminum heat-conducting sheets and special decoupling mats that replace the screed. Tiles can be laid directly on top. The total installation height with tiles is 5 cm from the bare concrete ceiling. Part 3 is about the leak test, also known as the pressure test. In my case, I tested the installation for leaks with compressed air, which is a bit more demanding than with water, but has the advantage of keeping the system frost-proof. #PressureTest #Renovation 00:00 Introduction and Test Report 02:34 Load Test 3 Bar 08:31 Leak Test 150 mBar