Getting Started with the ZNL – Compression Measurements
The Rohde & Schwarz ZNL vector network analyzer can be used to make measurements of gain compression and calculate compression points (e.g. P1dB) through its intuitive user interface. This presentation provides step by step instructions on how to make gain compression measurements, including explanations of the relevant configuration parameters and typical measurement results. Learn more about Rohde & Schwarz ZNL vector network analyzer: http://rsna.us/6051Ura2X Timeline: 00:00 Introduction 00:16 Suggested viewing 00:35 Review of compression measurements 01:37 Power calibration 02:35 Gain compression test setup 03:35 Configuring power sweep parameters 04:08 Basic gain compression measurement results 04:37 Determining compression point 05:26 Defining the reference using a marker 05:59 Defining the reference using a range 06:27 Configuring the (optional) receiver step attenuator 07:13 Summary
Measuring Filters with the ZPH
Understanding Gain Compression and P1dB
Understanding Third Order Intercept
Hardware in the Loop Testing: Real-Time EMT Simulation for Low-Inertia Grids
The Y-Factor Method: How to Measure Amplifier Noise Figure
PDN Impedance Measurements using the Bode 500 and Picotest PDN Probes
How to Use a Spectrum Analyzer: RBW & VBW Explained (Beginner Guide)
Accurately determine amplifier performance with P1dB measurement
Understanding Basic Power Sensor Measurements
The Iconic Bass Riff That NOBODY Can Play
#2030 2 Watt Amplifier 1dB Compression Measurement
Rowan Atkinson's Funniest Moments That Prove He's a Comedy Genius
Understanding VNAs - Power Calibration
GLOBALFOUNDRIES webinar: Analog Design Workshop for 22FDX 22nm FD-SOI Technology part I
When Animals Surprise Photographers in the Sweetest Way! 😍
#576 NANOVNA Measuring an Amplifier
#18: Use Oscilloscope with delayed time base to measure a RF Power detector
Billionaire's WARNING: I'm SELLING. The Crash Is Already Here!
