Si5351 VFO/BFO Software: Part 2 Software overview
Apologies for the quiet audio in this video. I’ve tried everything to make it better to no avail. please turn up the volume. Two part video series looking at the software setup used to drive the Si5351. Part 1 looks at the hardware and what's needed to be worked out prior to writing the software. Part 2 looks at the software using the knowledge gained in Part 1.
▶︎
Si5351 VFO/BFO Software: Part 1 Hardware overview
▶︎
Simple SSB Rig: Part 2 - VFO, Arduino Code, Si5351 Calibration
▶︎
Homebrew 80/40m SSB/CW Rig - #4a SSB Crystal Filter
▶︎
Learn MicroPython #1 - Introduction & Installation
▶︎
Marokko – Haiti Highlights | Gruppe C, FIFA WM 2026 | sportstudio
▶︎
Meta’s AI Clusterf*ck Is Humiliating Zuckerberg
▶︎
FPGAs Aren’t Processors (Unless You Want Them to Be) || FPGA Deep Dive and Use
▶︎
Wie nur ein Fehler Deutschlands größtes Maschinenbau-Imperium zerstörte
▶︎
Programming si5351 with the PyBoard
▶︎
Schottland – Brasilien Highlights | Gruppe C, FIFA WM 2026 | sportstudio
▶︎
Vinicius Jr. ice-cold, Ochoa celebrated | 2026 FIFA World Cup Highlights | Sportschau
▶︎
Si5351A Clock Generator Programming+
▶︎
CH32V003F4P6 Tutorial - Part 1 - Basic GPIO operations
▶︎
How to Build and Code an Arduino VFO Si5351 PART-2
▶︎
The Hard Fall of Porsche
▶︎
Homebrew MC1350P based SSB Rig - #4 VFO/BFO, BPF, DC Receiver Test
▶︎
How Massive Aircraft Engines Are Mass Produced Inside Complex Assembly Factory
▶︎
How to Calibrate the Si5351 on the Arduino Platform
▶︎
Multiband VFO with Arduino and si5351
▶︎