Drill Sharpening Jig - Part 7 & VFD Install
Back to the drill sharpening jig, and making the rear drill support with in-feed to the grinding wheel. Plus a look at how I installed a VFD on my vertical mill. Thanks to two friends of the channel, both from Melbourne: Andrew for donating a Mitutoyo micrometer head - which is now part of the drill sharpening jig. Lindsay of AET Aust Pty Ltd for donating a VFD - which is now part of my vertical mill. Cheers, guys.
▶︎
Back in the Workshop.
▶︎
Milling Compound Angles
▶︎
New Vertical Milling Head (VMH) - Part XII
▶︎
Prototype EC collet spring tool
▶︎
Schaublin Lathe Retrofit – She Cuts Again
▶︎
How a Failed Hedge Trimmer Company Built American Manufacturing
▶︎
Giving Plate Steel a Purpose
▶︎
How We Thread 30ft Drill Rods (Wild Megabore Setup!)
▶︎
I Built a Multi Use Angle Plate
▶︎
I made a dead accurate level from scraps (DIY machinist level)
▶︎
The Ten-Engine Titan: Inside the B-36 Peacemaker, The Cold War’s Largest Bomber
▶︎
Making a Milling Slide.
▶︎
Making a tailstock turret for the lathe (capstan attachment)
▶︎
Unusual Shop Tips
▶︎
How do you hold a part you can't grip? Machining precision washers with a Glue Chuck
▶︎
Exploring the Bizarre Aircraft Designs of WWII And The Remarkable Miles Aircraft Designs
▶︎
NT40 tool setter (Edited and reposted)
▶︎
Sharpen Drill Bits by Hand - Lost Tribal Knowledge
▶︎
Lathe Buying Tips - Don’t Make The Mistakes I Made
▶︎