Step-by-Step Belden REVConnect UTP Termination Instruction Video — Allied Electronics & Automation

Covers all the steps you need for any UTP termination; Cat 5e through 10GX Jack, and even the 10GX Field Mount Plug. Shop Allied: https://www.alliedelec.com/data-ether... To follow along, you'll need the following: cable (shown here: Belden 10GXS small diameter category 6A) REVConnect module (a modular UTP jack or unshielded plug) Core (cable manager and a cap; comes with each module) REVConnect termination tool, which features a wire stripper and a cross web cutter (ONLY tool needed!) NOT REQUIRED: 110 punch down, RJ45 crimper, flush cutters, etc. Step 1: Use tool to remove 2" (5 cm) of jacket. Cut rip cord. Remove tape barrier. Peel down pairs. Cut cross web. Tip - Use the guillotine tool to cut the cross web as close to the jacket as possible! Step 2: Separate pairs into two groups (blue/brown and orange/green). Decide on 568A or 568B termination (T568A: green and brown pair go up; T568B: orange and brown pair go up). Step 3 (T568B): Insert brown pair through brown slot and orange pair through orange slot. Slide cable manager down. Rotate cable manager until blue and green pairs are in respective slots. Step 4: Untwist pairs (DO NOT SEPARATE) until white conductor resides on outside. Bend down the management bar. Step 5: Snap on cap by aligning contacts across from wires. Slot core into REVConnect tool until latch realigns in center. Crimp handle once to terminate core. Step 6: Align jack and core latches to snap on housing. To remove, bend latch away from cable. Open plug doors and align plug and core latches to snap on housing. Close rear plug doors. Tip - To open plug doors, squeeze on them with one hand and push the vertical pins towards each other! The solution for any RJ45 connection you need to make. Reliable. Easy. Versatile. REVConnect.