Elevated Cube // Challenge #3 // #igow6

IGOW6 Challenge #3 = BetaFPV Elevated Cube Featured Rigs: Screamers BetaFPV Air II Frame BetaFPV Matrix 1S V2 WeBleedFPV 32,500kv Screamers Motors BetaFPV C03 Camera & Canopy O.R.T. Antenna Challenge Requirements: Requirement 1 = You must find or create an IGOW approved cube obstacle and then raise the base of it up to 5 feet (152cm) above the ground. 28" (71cm) max open size of each face. Any method of elevating the cube is allowed. Requirement 2 = You must perform a Split-S through opposite vertical faces of the cube and then as you pass under the cube immediately transition into a powerloop that starts in front of the cube and then dives down both horizonal faces and finishes passing under the front face again. Then perform a flip or roll through the cube. Requirement 3 = You must perform a Split-S down through the opposite horizontal faces of the cube and then as you pass under the front face of the cube immediately transition into a powerloop passes through opposite vertical faces of the cube while upside down at the top of the loop and finishes passing under the cube again. Then perform a flip or roll through the cube.