RDD1 WPL D12 drift test drive

Had another driver drive my 190mm wheelbase 3D printed RDD1 with a wpl d12 body an black box design body -Modifications are as fallowed -Middle chassis section modified for 190mm wheel base tamiya m-chassis cva shock in the front instead of rubber band custom back pod plate an mid plate for a m-chassis cva shock to help with motor pod twisting -Custom wheels for offset to match black box design's wpl d12 body and use fullsized 1/10 drift tire -Modified front bumper/front splitter holder -Modified rear pod for a 540 motor but unlike a lot of others this is round notched to try an get the motor inboard as much as possible -custom 8mm aluminum tube rear axle (same width as the stock RDD1's plastic axle) with 8mm to 12mm hex brass motor couplings with 4mm thread bore Specs -old savox low profile titanium gear servo running at 7.4v from esc's 7.4v 3amp bec -naughty dragon gyro.. (yes I know its a terrible name for a cheapo amazon gyro!) -P-tile drift tires (can't remember the exact brand bought them at the track to make sure I had the exact right tires!) -holmes hobby puller pro stubby v1 motor 2200kv with a 24t pinion an 87t spur -meus racing 4 channel nano receiver -flyingRC 75amp am32 esc with 7.4v 3amp bec enabled