Comment programmer 💻 et raccorder l'Arduino ⚡ avec un Shield Moteur L293D ? Inversion sens rotation

Operating principle, connection and programming of an L293D Motor Shield, allowing to reverse control of a DC motor and in particular by facilitating the reversal of the direction of rotation of the motor ↪️↩️ and by proposing the speed variation. In this video, I explain how to program an Arduino to control a motor via the L293D Motor Shield to reverse the direction of rotation of a DC motor. The wiring of the integrated circuit is done with flying wires. Find more information at https://electrotoile.eu/arduino-moteu... ------------------------------------------------------------------------------------------------------------------------------------------------------------ To complete the assembly, you will need: Motor Shield with L293D integrated circuit (https://amzn.to/3jxM7Mq) Clone or official Arduino board in Uno (https://amzn.to/33QpBk7) or Mega (https://amzn.to/2MVqpgR) version Precision screwdriver (https://amzn.to/2J66b2Y) DC motor with a maximum current of 0.6A or 600mA ------------------------------------------------------------------------------------------------------------------------------------------------------------ Program to send to the Arduino to control the DC motor via the L293D Motor Shield: int Moteur_sens1=4; // Arduino pin 4 to L293D pin A+ int Motor_direction2=5; // Arduino pin 5 to L293D pin A- void setup() { / Set Arduino pins 4 and 5 as digital outputs pinMode(Motor_direction1, OUTPUT); // Arduino pin 4 as digital output pinMode(Motor_direction2, OUTPUT); // Arduino pin 5 as digital output } void loop() { / The motor rotates in the normal direction digitalWrite(Motor_direction1, HIGH); // Enable L293D pin A+ digitalWrite(Motor_direction2, LOW); // Disable L293D pin A- delay(3000); // Wait 3 seconds / The motor is stopped digitalWrite(Motor_direction1, LOW); //Disable L293D pin A+ digitalWrite(Motor_direction2,LOW); //Disable L293D pin A- delay(3000); // Wait 3 seconds // The motor rotates in the opposite direction digitalWrite(Motor_direction1,LOW); //Disable L293D pin A+ digitalWrite(Motor_direction2,HIGH); //Enable L293D pin A- delay(3000); // Wait 3 seconds // The motor is stopped digitalWrite(Motor_direction1,LOW); //Disable L293D pin A+ digitalWrite(Motor_direction2,LOW); //Disable L293D pin A- delay(3000); // Wait 3 seconds } ---------------------------------------------------------------------------------------------------------------------------------------------------------------