Dash 8 Q400 - Taxi, departure and cruise tutorial
Welcome to the fifth video in my tutorial series. In this video we pick up where we left of last time, ready to taxi out to departure. We do our checks before lining up on runway 05, then climb out and start our cruise flight segment. This video is made for simulator use only. Please consult your operating manuals for real world use. Filmed in X-Plane 12.3.1 with FlyJSim Q4XP Dash 8 Q400. Would you like to support my channel? Buy me a coffee at https://buymeacoffee.com/toolowsimula... CPU: Intel i9-13900K GPU: AMD Sapphire Radeon 7900 XTX RAM: 64GB DDR5 6000 MHz Sim HDD: WD Black SN850X 1000GB Joystick: VKB Gunfighter Throttle: VirtualFly TQ6 and Thrustmaster TCA modded Rudder: MFG Crosswind
▶︎
Dash 8 Q400 - Arrival, descent and landing tutorial
▶︎
Dash 8 Q400 - Engine start tutorial
▶︎
Watch this if everything feels too much (gentle comfort for tired women)
▶︎
Russian Controller Has No Choice But To Break The RULES to Prevent Disaster
▶︎
AIRBUS COCKPIT WINDSHIELD CRACKED ON CRUISE
▶︎
Unbelievable Smart Worker & Hilarious Fails | Construction Compilation #7 #adamrose #smartworkers
▶︎
X-Plane 12 Complete Settings Guide 2026 + Q&A
▶︎
THIS Is What Happens When You Attack a US Aircraft Carrier
▶︎
B-52 CRASHES After Takeoff During Test Flight | Captain Steeeve Reacts
▶︎
Flight Simulator Lesson 1: Flight Instruments (NEWLY REDONE!)
▶︎
Real Captain Flies a Full A320 Route (No Missing Steps)
▶︎
Dash 8 Q400 - RNP automatic and manual approach tutorial
▶︎
China’s Secret | The Most Unbelievable Megaprojects in China | 4K Travel Documentary
▶︎
Death lurks beyond the borders
▶︎
The Airbus A220 Trap
▶︎
Dash 8 Q400 - ILS CAT1 tutorial
▶︎
Unbelievable Workers | Working with Talented Engineers #46 #fail #adamrose #smartworkers
▶︎
My solo flying lesson to Kiel goes wrong – does this mean the end of my training?
▶︎
She Was Sleeping in 8A — When the Captain Asked if Any Combat Pilots Were on Board
▶︎