How to Replace Crank Position Sensor on a Gm 3800

In this video I show you how I replace crank position sensor on a 1988 Oldsmobile Delta 88 , other General Motors vehicles with the 3.8 will be very similar. If you find this video helpful, subscribe. I put out a repair video every week. Thanks for watching. As an Amazon Associate I earn from qualifying purchases. There is no cost to you. It's a great free way to support Grim Repair, Thank you. Link to crank position sensor with 3 pin plug - https://amzn.to/3howByb Link to crank position sensor with 4 pin plug - https://amzn.to/3ntYQ27 Link to crank position sensor mounting bracket - https://amzn.to/3tHr7n6 Link to feeler gauge - https://amzn.to/2Xdgufj Disclaimer: Due to factors beyond the control of Grim Repair, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. Grim Repair assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Grim Repair recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of Grim Repair, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not Grim Repair. Links included in this description might be affiliate links. If you purchase a product or service with the links that I provide I may receive a small commission. There is no additional charge to you.