How to make canister filter using submersible power head

DIY canister filter using submersible pump for aquascape filter. Subscribe : https://goo.gl/J4sgjG This filter is made from a 4 inch PVC pipe that is closed at the top and bottom. The top and side pipe connections used a plastic tap that has been cut. In this canister filter there are several filter media, namely coarse foam, medium foam, fine foam, bioball, and coral. The pump used is an internal power head type that is placed on the top PVC pipe cap. Before being run, the filter must be filled with water first, the method is as follows: 1. Place the filter in a lower position than the aquarium. 2. Install the filter input into the aquarium (can use a plastic hose or pipe) 3. Suck the filter output (only takes 1-2 seconds) can by mouth or by suction pump. 4. Wait until the filter is fully charged. 5. Install the filter correctly in the aquarium based on constructs and layouts. 6. Run the canister filter. NOTE: Use strong and waterproof glue for cable holes and other connections as needed. You can also add a small hole on top as a drain of air but a tap must be installed. You can change filter media based on your concept and your experience. How to make external aquarium filter:    • How to make external aquarium filter from ...   DIY Canister filter using a jar:    • DIY external aquarium filter using a jar   Under Gravel Filter:    • How to install under gravel filter in smal...