2011-2014 5.0L Coyote Mustang: How To Install Transmission, Clutch, Flywheel, & Slave Cylinder

In this video, Landan explains the procedure of how to install a manual transmission, clutch, flywheel, slave cylinder, and other related components into a Ford Mustang GT with a 5.0L Coyote engine and MT82 manual transmission. Product Links 11-14 Mustang Transmission Parts: https://lmr.com/products/10-14-Mustan... Watch How To Remove Transmission, Clutch, Flywheel, & Slave Cylinder:    • 2011-2014 5.0L Coyote Mustang: How To Remo...   How To Replace 5.0L Coyote Rear Main Seal:    • How To Replace 5.0L Coyote Rear Main Seal ...   Coyote Crankshaft Sensor Ring - What is it & How To Install:    • 2011-2023 Mustang 5.0L Coyote Crankshaft S...   Tool List Transmission Fluid (per application) Transmission Additive (per application) Brake Fluid (per application) Handheld Tuner or Ford IDS (for crank relearn procedure) Jacks & Jack Stands or a Lift Transmission Jack Paint Pen Shop or Microfiber Towels Brake Clean Wire Brushes Anti-seize Blue Thread Locking Compound Clutch Disc Alignment Tool Ball-peen Hammer Set Punch Set Flare Nut Wrench Set 1/2" Socket Set 3/8" Socket Set 3/8" Extensions Wobble Adapters T-30 Torx Bit or Socket 8mm Hex Socket Long-reach Panel Removal Tool Combination Wrench Set Pick Set Prybar Set 3/8" & 1/2" Torque Wrenches 7/8" O2 Sensor Tool (optional) 3/8" Wobble Socket Set (optional) Chapters 00:00 - Intro & video explanation. 02:18 - Install the pilot bearing (optional). 02:43 - Open the clutch & categorize the contents. 02:55 - Install the locating dowels into the flywheel. 03:28 - Install the spacer plate onto the engine block. 03:56 - Install the flywheel. 05:22 - Install the clutch disc & pressure plate. 06:54 - Remove & install the slave cylinder. 07:51 - Fill the transmission with fluid (if you drained it) & prep for reinstall. 08:26 - Install the transmission. 10:07 - Install the transmission crossmember. 10:33 - Install the output shaft speed sensor & inspection plate. 11:00 - Install the starter & connect the clutch line. 11:34 - Install the head shields (if removed) & the driveshaft. 12:16 - Install the upstream oxygen sensors & install the mid-pipe. 13:28 - Install the k-member brace. 13:35 - Add fluid to the master cylinder or clutch reservoir (if applicable) & bleed the system. 14:08 - Install the engine bay components & reconnect the negative battery cable. 14:17 - Perform a crankshaft relearn. 14:35 - Final thoughts & outro. #lmr #mustang #clutch Use of this video is subject to the terms as set forth in our LMR Install Video Disclaimer | https://lmr.com/page/lmr-install-vide...