RAMPS 1.4 - Adding 3 or more Extruders
This explains the process of adding 3 or more extruders. One Time Tips, You Can PayPal Me: https://www.paypal.me/EBraiman Discord: / discord Patreon: / edbraiman buymeacoffee: https://www.buymeacoffee.com/ebraiman Required Hardware: Arduino 2560 with USB cable RAMPS 1.4 2x-ExtrudrBoard Nema17 motor. A4988 Stepper driver Required Software: Arduino studios 1.8.2 or higher https://www.arduino.cc/ Pronterface.exe http://www.pronterface.com/ MarlinFW (Firmware 1.1.6) http://marlinfw.org/meta/download/
▶︎
RAMPS 1.4 - LCD (REPRAP DISCOUNT SMART CONTROLLER)
▶︎
RAMPS 1.4 - BLTouch
▶︎
RAMPS 1.4 - Mechanical Filament Sensor Runout Configuration
▶︎
Shielding CNC Electronic Wires - How to Eliminate EMI (Interference)!
▶︎
Ramps 1 4 basics Part 1; parts
▶︎
RAMPS 1.4 - Hot end and Thermistor install and Marlin firmware configuration
▶︎
RAMPS 1.4 - Stepper Driver install - basic
▶︎
How Huawei Just Built an Impossible Chip
▶︎
I Made the Drone I Couldn’t Buy
▶︎
I made a GPU at home
▶︎
Something is jamming GPS over Europe. Here's what we found
▶︎
I Hacked This Temu Router. What I Found Should Be Illegal.
▶︎
Toothless Gears Make Much More Torque Than Conventional Ones, Here's How. Cycloid Drive Explained
▶︎
RAMPS 1.4 - Basics
▶︎
RAMPS 1.4 - Optical Filament Sensor configuration
▶︎
The Internet, Reinvented.
▶︎
How FAST is KLIPPER REALLY? ...CHEAP BED SLINGERS go Ferrari mode?
▶︎
RAMPS 1.4 - Endstop switch
▶︎