BMW E90 Stoßdämpfer hinten wechseln

In this video, we are replacing the shock absorbers of an E90 320i at ~150.000km. Worn shock absorbers are often not identified as the handling only gradually worsens. Preventive replacement is reasonable at about 150.000km. If the absorber leaks oil, you should replace them immediately. The shock absorber is assembled as following, from bottom to top: Bottom Support Bearing Shock Absorber Dust Cover Additional Bumper Supporting Cup Upper Support Bearing, Lower Part Sealing Gasket Then, put on via the trunk: Upper Support Bearing, Upper Part As the parts vary depending on the engine, transmission type, configuration and whether it's the sport or normal setup, no part numbers will be listed. A lot of online car part stores only display suitable parts after a vehicle has been entered. This is the shopping list: 2x Rear Shock Absorbers 2x Support Bearing, Bottom 2x Support Bearing, Top, Lower Part 2x Support Bearing, Top, Upper Part 2x Dust Cover Set (almost always includes the additional damper) Required Tools: ➥Sockets sized 6, 16, 17 ➥ Open Jaw Wrench size 16 ➥ Screwdriver ➥ Torx 30 ➥ E15 Outer Torx ➥ Plastic Wedges ➥ Car Jacks ➥ Hydraulic Car Jack Warning: Never get under the car when it is not secured with a static car jack! Tightening Torques: ➥ Shock Absorber Bottom Screw: 38Nm ➥ Shock Absorber Top Screw: 27 Nm (If you apply the torque at the absorber directly using a size 6 socket, the torque wrench needs to be able to tighten counter-clockwise) ➥ Wheel Screws: 120 Nm ✔ Requirements ➥ E90 Cost of repair: ~170 EUR Difficulty: Medium Was the video helpful to you? Get us a coffee :-) https://www.buymeacoffee.com/AcureTech