Cutting table for roller blinds TA M3000

Tables M series with manual knife feed is the most budgetary option for small manufacture. The table is completed with a one-sided pneumatic clamp and a disс knife. Unwinding shafts are made of polished stainless steel. In the basic configuration, the shafts are not movable in the transverse direction. Centering system can be optionally installed to align the roll. The back light section for fabric control is also an option and can be installed on this table. The clamping plate drive is pneumatic. The cutting of the fabric is carried out manually with an electric circular knife. Optionally can be installed a synchronous parallel stop over the entire width of the table, it allows you to quickly and accurately set the size and parallelism of the cutting line. The lower part of the stop have no clearance to the table along the entire length, which does not allow the fabric to slip under the stop bar. It is possible to install an ultrasonic knife on the table, which solders the edge of the fabric and prevents the fraying at the edges on some types of fabric. Changing the disc knife to an ultrasonic knife will take about 5 minutes.