簡単に付くはずが…最悪の展開に【GDBインマニ流用】

This time, when I tried to install a GDA intake manifold, it didn't fit at all... There was interference everywhere, and it was a nightmare far worse than I imagined. This video summarizes the actual interference points, modifications needed, and the installation process. I hope this will be helpful for anyone considering using a GDA intake manifold or doing it themselves. ⸻ 【Contents of this video】 ・Parts needed when using an intake manifold ・Checking the areas of interference ・Necessary modifications ・Actual installation work ⸻ ■Vehicle Information GDB Impreza (mid-model) ⸻ ■A word from me You shouldn't try this kind of modification, everyone 🙂 It's incredibly difficult 😇 ⸻ 🧰 Video Chapters 0:00 Opening 1:16 Comments 2:12 Original Parts! 3:04 Work Begins! Water pipe gasket replacement & re-tapping 5:36 Unexpected... 6:01 Impulse purchase of STi parts 6:39 Injector and fuel pipe assembly 12:51 Engine harness assembly 14:11 Regulator adapter assembly 15:56 Wiring clip modification 17:11 Injector cover installation 18:44 Renewal of silicone hoses in the engine compartment 20:45 Docking the intake manifold to the vehicle 21:32 Accident with the engine harness 22:55 Accident with blow-by and fuel line 24:58 Forgotten sensors and had to remove again 27:40 Suction hose installation 29:38 Oil control valve, oil pressure, water temperature coupler installation, PCV, temperature sensor, blow-off valve vacuum, knock sensor coupler, fuel line assembly 30:30 Accident with the power steering pump 31:43 Trouble at the bottom of the pressurized tank 33:41 Machining is justice 35:16 Installing the pipe at the base of the blow-off valve 36:40 Installing the power steering pump is tough 38:17 Accident when tightening the intake manifold 38:57 Installing the throttle body 39:38 Test fitting 41:22 Installing the alternator, accelerator cable bracket, and ignition coil coupler 43:28 Accident with the intercooler 46:17 A silly mistake after installing the accelerator cable 46:40 Installing the air cleaner box, pulley cover, battery, and duct 48:28 Engine start 49:03 Starting again and ending ⸻ 👇 Please support Aki ch by subscribing, liking, and hyping! I read all the comments 😊 ⸻ 📩 Business/Collaboration Requests Please DM me on X   / akich19891031   ⸻ ▼ Social Media & Channels ☞ Aki ch    / @aki_ch   ☞ Aki ch Type M    / @akich-type-m   ☞ Threads https://www.threads.net/@aki.ej20 ☞ Twitter   / akich19891031   ☞ Instagram   / aki.20   ⸻ ▼ Music Used Song: LFZ - Popsicle [NCS Release] Music provided by NoCopyrightSounds Free Download/Stream: http://ncs.io/Popsicle Watch:    • LFZ - Popsicle | House | NCS - Copyright F...   ⸻ #gdb #impreza #modification #diy #subaru