Large DIY 3D printer 2 - completing the build

I have completed the large 3D printer build! Larger prints will be presented in the next video. Please note that this is a low budget build. I am not using the best components available. (by far). I am using whatever I already have or can get hold of as cheap as possible. I followed up this PoC build with the new and improved RIFF 600/900 design. The cad for that version is available. Update: consider probing just 3 points during the z-tilt. Probing 4 point might give unpredictable results. Some facts about the build: • Filament: Isanmate ASA (black), Fiberlogy ABS (light green) and SUNLU PETG (black) • Build plate 300 x 900 • 2020 and 2040 alu extrusions • SKR 1.4 turbo and SKR Pico controller boards • Radxa Rock 3C SBC • MGN 12H rails/carriage on Y and X • 12mm rods and bearings on Z • Cartesian • Klipper • Sensorless homing on X and Y • Dual Y stepper motors/drivers • Stealthburner • 3 x 360W power supplies • Dual mains switches/fuses Timestamps: 00:00 Trollolo 00:18 Short recap 00:45 The completed printer 00:57 The outside explained 02:07 Thrustbearings 02:50 Kinematics 04:11 Electronics 05:57 Klipper config 07:32 Movement and first prints 07:45 Skippable? 10:01 Rough first print 10:22 A part for the Voronish 11:13 A cube 12:35 Heightmap #largeprinter #3dprint #DIY