SPECTRA: Full Machine Set Up

Congratulations on your Spectra Smart Cooler! 🎉 In this video, we’ll walk you through how to safely unbox and set up your machine. These instructions apply to all Spectra smart coolers. 🔧 What You’ll Need Box cutter or utility blade Phillips screwdriver A second person (recommended for safe lifting) 📦 Unboxing & Setup Steps ⚠️ Important: Do NOT open the cooler door until the unit is completely off the pallet to prevent tipping. Remove the shrink wrap and cut the shipping straps. Cut and remove the corner protectors. Lift off the top lid and remove all surrounding cardboard. Remove the plastic bag covering the machine. Using a Phillips screwdriver, remove the silver leg braces from all four legs. Remove the three remaining silver corner protectors. 🚚 Removing from the Pallet 👥 You will need a second person for this step. Carefully walk the cooler backward off the pallet. Once there’s enough clearance, tilt the machine so two legs are on the ground. Slide the pallet out from underneath the remaining legs. ⚠️ Reminder: Do NOT open the door until the machine is fully off the pallet. 🔌 Final Setup 🔑 The keys can be found on the back of the machine or attached to the power cord. 🔌 The power cord is typically taped to the side of the unit. 📡 Locate the network antenna inside the top of the machine and place it on top for optimal signal. 🌐 For a wired internet connection, plug your CAT5 cable into the designated port. ⚙️ Control Area Setup (If Hardwiring Internet) ✅ Power Up Once your cooler is in its final position, plug it in and you're ready to go! This video will also teach you how to: Install the handle on you Spectra smart cooler Set Up your machine products and planogram in the VMS & OPS App Add new products to the Global Database Use the OPS App to restock your machine Set up Tax Jurisdiction Review Orders and Transactions #spectra #smartcooler #setup #vms #ops #restock #sales #orders #transactions #planogram #Spectra #SmartCooler #Setup #Installation #howto