[Tips 4] Hydra Aqua Peeling Facial Machine 7 in 1 Tutorial Accessories | h2o2 Radio Frequency

Hi there! In this video we’re going to tell you about the different accessories of our Hydra Oxygen Machine. 0:00 Introduction 0:07 SPRAY GUN 0:11 VIAL 0:33 NEEDLE 0:45 ABRASION PEN 0:57 O-ring 1:20 Filters 1:40 TIPS 2:16 SKIN SCRUBBER 2:25 FUSE 0:07 SPRAY GUN The spray gun has a silicon edge to attach a vial. 0:11 VIAL Bruun’s machine includes two vials. You can keep the spare one in a safe place and use it as a replacement, or change the vial depending on the product you want to use. To install the vial, just fill it with a tonic or liquid solution and attach it to the spray handle. To remove it, just pull the vial downwards. 0:33 NEEDLE The device includes a needle to open the spray gun in case it gets clogged. Poke the hole of the sprayer with the needle either to unclog it or just to clean it after each use. 0:45 ABRASION PEN The abrasion pen works together with the liquid solutions found in the machine’s bottles. Before starting with the treatment, make sure each of the abrasion pen’s parts is well set. These parts include an O-ring, a filter and the tips 0:57 O-ring The pen requires an O-ring, which prevents water from leaking during water suction. You may need to replace it eventually if it gets damaged. To do so, remove the old one and replace it with one of the spare O-rings. 1:20 Filters After some uses you will need to replace the filter of your pen. To do so, remove the old one, place the spare round filter on the top of the pen and press it slightly with your fingers. The central part will come off and you would just need to place the tip of your choice on top. 1:40 TIPS There are 6 types of tips available for your abrasion pen and they all adapt to every type of skin and liquids. Choose the tip you want to use and after attaching the filter to the pen, put the tip on top and press it to fasten it. Every tip has a different shape: plain, at an angle or spiraled, allowing estheticians to work comfortably and adapting to different skins. You can even change the tipduring the treatment by pulling the tip upwards and replacing it with the new one. 2:16 SKIN SCRUBBER A- Cover Remove its cover before beginning the treatment 2:25 FUSE If your machine does not turn on, you might need to replace its fuse. To do so follow these steps: Turn it off and unplug it. Using a screwdriver, remove the compartment that is located between the switch and the plug. There, you will find the damaged fuse. Remove it and replace it with the spare one by pressing it. Put the compartment back into the machine Plug the connector again and check the machine works. Fuse: F25AL250V Purchase link: https://bruunbeauty.com/Hydra-Tutorial Visit our website www.bruunbeauty.com PROMO CODE: INSTA10 ✨ GET 10% OFF discount using this promo code in our store.