Ford 8.8 IRS Rebuild

I decided to rebuild my own rear end after getting a few quotes to do it for $500. The process wasn't too bad, and so far I've driven nearly 500 miles on it with about 600whp and it feels great and is very quiet. I had access to most of these tools which helped, but I did have to buy some specialty tools that I didn't have. This should be a fairly complete list of tools needed to do this job: Tools needed: 9/16 wrench x2 hammer (hard and soft) brass punch chisel 1/2 impact with 27mm and 19mm Press bearing press kit bearing seporator large breaker bars x2 three jaw puller pinion holding tool beam style torque wrench a few m10 bolts to hold the pinion holding tool to the pinion flange Axle remover tool slide hammer micrometer torque wrench good for 100 ft lbs Dial Indicator with Magnetic Base A small pry bar Parts needed: Rebuild kit axle bearing and seal kit Black RTV Differential - Eaton detroit tru track (optional - this is what I used) Ring and pinion - Ford racing (optional - this is what I used) If there's some interest I'll expand on those part numbers for the tools or the rebuild parts.