MGB Electronic Ignition! Making the change 1977-80
In this video, I make the switch from points to an Accuspark electronic distributor (same instructions for Pertronix). It's not as straightforward since the '77-80 uses the 1.5 ohm coil and the ballast wire that runs up around the front of the car.
▶︎
Electronic Ignition trouble - MGB
▶︎
How to install Pertronix Electronic Ignition
▶︎
Replace Light Switch Classic VW Beetle
▶︎
MGB Electronic Ignition
▶︎
Late MGB ignition issue / common mistake
▶︎
8. MGB electronic ignition and RVI rev counter
▶︎
Electronic ignition for your Classic A-series
▶︎
Pertronix Flamethrower Installed in 1977 MGB
▶︎
278 MG Tech | Converting Positive Earth Tachometer
▶︎
MGB GT Distributor and Coil - Lessons in electronic igntion
▶︎
Measuring ignition coil primary resistance
▶︎
INTRODUCTION TO THE MGB IGNITION SYSTEM | CLASSICMGB
▶︎
020 MG Tech | MGB Electricals 1977-1980
▶︎
Crap To Cream, my MGB modifications / upgrades, me explaining what they are and why I did them.
▶︎
how to wire ELECTRONIC IGNITION on ANYTHING custom automotive wiring from scratch part 3
▶︎
Fitting AccuSpark Electronic Ignition to MGB
▶︎
Pertronix Ignition "Problems & Failures" (It's Actually YOU)
▶︎
MGB GT 1981 - Fitting an Electronic Ignition Conversion Kit
▶︎
255 MG Tech | Phased Out PERTRONIX
▶︎