How to change lower unit oil on 1996 Mercury 115 HP 2-Stroke using Quicksilver SAE 90 Gear Lube
These instructions are for models which have both an OIL LEVEL and VENT screw at the top and a FILL hole at the bottom. May apply to other models. Sorry in advance for all the cuts and edits, the traffic going by was loud. Requires: 30 Minutes of Time 1 Quart Quicksilver 858064Q01 High Performance SAE 90 Gear Lube Quicksilver 19183Q02 3/8" Fill Hole Screw Seals (4-Pack) Shoreline Marine Pump Large Flathead Screwdriver Container for old oil Paper towel/rags
▶︎
1996 Mercury 115 (2 Stroke) Water Pump Replacement
▶︎
How to Change Mercury Outboard Motor Gear Lube | Mercury Optimax 2-Stroke Lower Unit Maintenance
▶︎
How To Reseal A Lower Unit
▶︎
How to Change Gear Lube on an Inboard/Outboard Motor
▶︎
Replacing outboard oil seals the hack way
▶︎
Boat Ramp DISASTERS Caught On Camera !
▶︎
How A Lower Unit Fills Up With Water
▶︎
Mercury Built The Perfect 2-Stroke... Then Made it Disappear
▶︎
How to Fix any 2 Stroke Outboard (This is Everything I Know)
▶︎
How to change gear oil on Mercury 90hp - CHANGE your own Lower Unit OIL
▶︎
How to Change Lower Unit Oil (2-Stroke Outboard)
▶︎
Replacing Lower Unit Seals on an Outboard Boat Motor WITHOUT Expensive Tools!
▶︎
How To Replace Mercury Outboard Water Pump Impeller
▶︎
Lower Unit Removal & Water Pump Replacement on 1996 Mercury 115 hp 2-Stroke Outboard
▶︎
Replacing Poppet Valve Carrier and Grommet Quicksilver Kit 803060T1 (1996 Mercury 115 2-Stroke)
▶︎
How to Properly Flush Your Motor
▶︎
How To Change Lower Unit Oil on new Mercury FourStroke 250
▶︎
Top 10 Most Common Outboard Problems (and how to fix them)
▶︎
Starting the Evinrude 90 HP 2 stroke outboard boat engine.
▶︎