Настройка нижнего и верхнего положения полотна автоматических ворот DoorHan

http://www.383servis.ru/ In this video: Setting up the gate. Setting up the gate position. Setting up the door leaf position. Setting up the upper and lower end positions of automatic gates. Instructions for Setting the End Positions of Sectional Doors with Sectional automation on models SE-750 SE-1000 SE-1200 DoorHan Fast -750 DoorHan Sectional-750; Sectional-1200. Programming the drive must be step-by-step, with the final step being recording and saving to memory. The first step is to program and record the upper end position of the door leaf, and the second step is recording the lower end position. Remove the display cover to access the control buttons. Press and hold the P key. The display will show the channel number that is ready for programming. Channel 1. This is the upper end position. Press the P button to edit the channel program. The first channel's number will start flashing. The drive is now in the upper gate position setting mode. Now use the + or - buttons to set the desired upper position. Next, use the - button to change the setting to the lower position, channel 2. Press the P button to enter programming mode. Now use the + and - buttons to set the lower position of the sectional door. Save this position by pressing the P button. Go to channel 1 and hold the P button until 0 appears on the display. The upper and lower gate positions are saved, programming is complete. Subscribe to the channel to always have video instructions at hand, and visit the official website for the exact technical specifications of DoorHan automation. ____________________________________ In this video: To configure the gate. To set the position of the gate. To set the position of the gate. To adjust the top and bottom position of the gate. Programming the drive should be step-by-step and the final destination should be recorded and saved in the memory. First action is mandatory for programming and recording the top position of a cloth of the gate, the second action recorded lower end position. Remove the display to access the control buttons. Press and hold the P key The display shows the number of the channel that is ready for programming. The first channel. Is responsible for the top position. Press the P button for editing program channel. The figure of the first channel will blink. At the moment, the actuator is switched mode, in the top position of a cloth of the gate. Now press the or minus installed we need top position Next, click the minus transfer the setting to the lowest position, channel 2 Press P to log in programming mode. And custom keys plus and minus lower position of sectional door. Recorded this provision in the memory by pressing P. Go to channel 1 and hold the P button until the display 0. The upper and the lower the position of a gate cloth saved, programming is complete.