Sua PISCINA NUNCA vai VAZAR se VOCÊ fizer ASSIM! Chumbamento da Tubulação de Piscina.

Contact. (31) 2520-5059 Miranda Leal Office (31) 9 9191-0296 WhatsApp In this video, Erika Miranda and José Ricardo Leal of Miranda Leal Engenharia will give tips on how to anchor pool pipes. One of the biggest problems in pool and spa construction is anchoring the pipes. If the pipes aren't properly anchored, the pool will leak. If the pool pipes aren't properly anchored, when the plumber installs the plumbing system, they'll move the pipes, displacing the waterproofing, and your pool will leak. So, here's the first tip: Earthen anchor the pipes and install the entire plumbing system before waterproofing. This way, when you test the pool, you'll also test the plumbing system. Now for the life-saving tip! Cut the pipes to approximately 60 cm, wrap them with tape, leaving 20 cm on each side. Cover the pipe in the center with Sikadur and dip it in the sand like this. Now just anchor it. Do this after the pool is plumb and squared so that the pipe is perpendicular to the wall... otherwise, the device won't stay flush against the wall; it will end up inverted. I suggest using a 2:1 compound with bianco and carefully anchor the outside of the pool. Remember that the hole must be at least 3 gauges larger than the pipe to be anchored. In other words, if you're anchoring a 50 mm pipe, the hole must be at least 85 mm. Make a pan around the pipe to improve the adhesion of the waterproofing. There's no point in just pouring the compound on the pipe; it won't adhere. Is this method good? Leave a comment below... Big hug and see you next time!