1990-1997 Accord Brake Job (Captive Rotor Replacement) Hub Over Rotor Part 1

Part 1 : Removal In this video I show you how to replace captive rotors on 1990-1997 Accords. On captive rotor designs also referred to as a rotor over hub design the rotor is bolted behind the hub. Which makes it more time consuming to remove than the more common rotor over hub design where the rotor sits on top of the hub. The job isn't too bad but it will take considerably longer than a more common rotor over hub brake job which you may be familiar with due to the extra steps involved. So be sure to give yourself some extra time. The axle nut unstaking tool is SP Tools part number 65400. The long bolts used are M10 X 1.25 X 100mm. "Welcome To The Show" Kevin MacLeod (incompetech.com) Licensed under Creative Commons: By Attribution 3.0 License http://creativecommons.org/licenses/b... Due to factors beyond the control of Bushougoma, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. Bushougoma assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Bushougoma recommends safe practices when working with the tools or equipment seen or implied in this video. No information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not Bushougoma.