How to make a resin dragon egg with no lathe

On this episode of Bens Worx I cast walnut burl in epoxy resin to make a resin dragon egg. I left it to cure in the pressure pot and then shaped it using a sander, I polished it up with some Yorkshire grit on the buffing wheel. if you would like to buy some of my creations you can check out my Etsy shop: https://www.etsy.com/au/shop/Bensworx... If you like watching my videos and would like to support my channel you can check out my Patreon page and become a Patron, All support is gratefully appreciated!   / bensworx   Use code bensworx to get a 5% discount off your order at https://www.solarcolordust.com I used chameleon pigments on this egg, you can find them here https://solarcolordust.com/t/sample-p... Get 10% off ArtCast resin and all pigments just use code BENSWORX10 at https://www.justresin.com.au Want to send me something? send it to: BENSWORX PO BOX 3318 LOGANHOLME 4129 QLD Australia If you would like to use the same resin and pastes i use in my videos go check out: https://www.justresin.com.au The lathe i use: https://www.machineryhouse.com.au/W385 If you would like to purchase any of my pendants you can buy them here: https://www.ebay.com just search bens worx ________________________________________________________ All Business Enquiries Email me @ [email protected] Follow me for sneak peeks of upcoming projects Facebook ➡️   / bensworx1   Twitter ➡️   / isbenny69   Instagram ➡️   / bens_worx   __________________________________________________________ Thanks for watching! #resin #dragonegg #casting