Bidet: Installation Rohre Wandscheiben

In this short installation guide, we explain the manufacturer's regulations and specifications, as well as the dimensions and positions of the mounting brackets (threaded rods), pipes, and wall brackets for hot and cold water. We would be very grateful for a donation to support our work on YouTube. You can donate to the following PayPal account: [email protected] or use the link: http://paypal.me/ImmoSchoen We show where the water outlet can be installed in the bidet and that there is no uniform standard. Rather, each manufacturer (Grohe, Keramag, Geberit, etc.) has different dimensions for the mounting bracket, water connection, and wastewater connection. In our comprehensive introduction to installing a bidet on the wall without an unnecessarily expensive pre-wall system, we address the specifications of the manufacturers (e.g., Grohe, Geberit, Viega). The 8cm distance between the wall plates (wall brackets, ceiling brackets, and wall connection) for the two drinking water connections is explained. It is usually located at a height of 9 cm, but this is technically difficult to achieve without a pre-wall system. Hot water is always on the left and cold water on the right. When laying the pipes, the installation height and the routing of the pipes must be considered. For the wall plates, the subfloor must be hollowed out and leveled with a hammer and chisel. The wall angle is then screwed in and plastered in. It is protected with construction plugs. The construction plugs also allow you to determine the alignment of the wall angles and check this with a spirit level. Composite pipes (sensitive pipes) are laid in flexible corrugated pipe. The wall plates on the bidet have a 16 mm (DN16) inlet and a 1/2" IG (1/2 inch internal thread) outlet.