STOP Ender 3 V3 SE Wobble! Support Rods + Updated Side Mount Mod

Fixing the infamous Z-axis gantry wobble on the Creality Ender 3 V3 SE and KE when printing at high speeds! Today we are installing the YOOPAI Support Rod Kit to stiffen up the frame and running a custom honeycomb stress test at 220mm/s to see if it actually improves print quality. But there’s a catch: the new support rods completely block our original side-mounted spool holder mod. To solve this engineering puzzle, I went back to the drawing board and designed the SR1 Version (Support Rod Version 1) spool holder. It snaps directly onto the YOOPAI stabilizer bars, uses the bottom brace cavity as a rotational counter-torque anchor, and prints completely support-free in under 2 hours! I've also redesigned the filament guide to utilize the new top steel plates with an optional 40mm bar magnet slot. If you’re tired of wavy layers and a dancing filament spool at high speeds, this setup is for you. 👇 ENTIRE CREATOR TOOLKIT, MOD FILES & PARTS BELOW 👇 🔥 GET THE YOOPAI SUPPORT ROD KIT: ➡️ https://amzn.to/4eOxL4x - unfortunately, the official kit is not available currently. (Amazon Affiliate) 📦 DOWNLOAD MY CUSTOM 3D MODS (FREE): ➡️ Thingiverse:https://www.thingiverse.com/thing:735... ➡️ Printables: https://www.printables.com/model/1724... ⏱️ TIMESTAMPS: 0:00 - The Gantry Sway Problem at 220mm/s 1:43 - What's Inside the YOOPAI Kit? 2:51 - Crucial Step-by-Step Installation & Pro-Tip 5:31 - Testing the Stabilizing Bars (Spool on Top) 5:50 - The Clearance Problem: Redesigning the Side Mount 6:36 - Meet the SR1 Snap-On Spool Holder Mod 7:50 - Magnetic Filament Guide Redesign 8:36 - Final Results: Worth It? 10:00 - What’s Next? (Creality Run-Out Sensor!) #3dprinting #ender3v3se #ender3upgrades #creality #3dprintermod #yoopai #printables #thingiverse