IP2312 modul încărcare acumulatori Li-Ion | Testarea tensiunii și a curentului de până la 3A

✔️Hello! In the video above, we analyzed and tested a lithium-ion battery charging module based on the IP2312 integrated circuit. Specifically, we adjusted the value of the RICHG resistor for charging currents of 1A, 1.5A, 2A, 2.5A and 3A. Then we tested the charge termination current, depending on the set charge current. Furthermore, we also checked the precharge current when the battery voltage is below 3V. Next, we measured and calculated the module efficiency, and the last test was the change in the output voltage. Finally, we drew some conclusions. ✔️Contents: 00:00 - Introduction 00:32 - IP2312 module presentation 02:18 - Choosing the RICHG resistor for charging currents between 1A and 3A 05:12 - Testing the charge termination current at set currents between 1A and 3A 06:01 - Precharge current test below 3V 06:35 - Measuring and calculating efficiency 07:36 - Changing the output voltage 09:43 - Conclusions 12:24 - End For other similar videos, access the links below: ►Presentation and testing of lithium ion battery charger with TP4056:    • Prezentare si testare incarcator acumulato...   ►Panel indicator with LED display for battery level / Electronic analysis and practical testing:    • Indicator de panou cu display LED pentru n...   ►Testing Li Ion battery charging kit with TP5100:    • Testare kit incarcare acumulatori Li Ion c...   📌If you liked this video, don't forget to LIKE 👍 and SUBSCRIBE ⚡