How to Replace 2008-2013 Nissan Rogue Rear Bumper

We are going to walk you through a 2008-2015 Nissan Rogue rear bumper cover removal and installation. The process is not as difficult as you may think it is. Learn how to replace a rear bumper cover for a 2008-2013 Nissan Rogue and 2014-2015 Rogue Select. Where to buy: http://bit.ly/10RogueRearBumper 0:00 Start 0:15 Tools needed 0:35 Start on the wheel wells 2:31 Remove the bottom bumper bolts/clips 4:49 Remove center bolts under the liftgate 4:50 Take the bumper off 6:18 Mount your new bumper 8:40 Secure the bolts on the wheel well 10:00 Secure the bottom bumper 13:46 Secure the top center bolts 14:26 Outro All bumpers, front and rear follow the same engineering process. There is a set number of bolts, screws, and, or plastic push pins that secure the bumper in place. Subscribe: https://www.youtube.com/c/Revemoto?su... The only tools you'll need are a flat-head screwdriver and a socket wrench with a 10mm socket. That's it, no special tool, no crazy body shop techniques. Just a couple tools and some elbow grease. If you remove and install this bumper, you can pretty much do it for a majority of vehicles. Subscribe: https://www.youtube.com/c/Revemoto?su... The best place to start would be on the wheel wells. There is usually a mixture of plastic push pins and bolts/screws holding the bumper to the frame of the vehicle. The push pins are the easiest to remove using panel clip pliers. However, you can use a flat-head screwdriver and pry the push pinout. It can be frustrating at first but you just pop the push pinout. Repeat on both sides of the bumper and be sure to not lose any of the bolts or push pins. Once those are off, make your way to the bottom of the bumper. You don't have to raise this Nissan Rogue off the ground. You should have enough clearing to lay underneath the car and take out any pins or bolts. Lastly, open the tailgate and remove the bolts. Once they are removed, safely pull the corners of the bumper from the wheel well. The bumper should fall off with ease. If it doesn't, go back and check to see if you missed any bolts or screws. Grab your newly painted bumper and snap it on. Be sure that the bumper clips on correctly to the brackets on the quarter panel. These brackets can break in an accident and need to be replaced. If your bumper won't clip on the bracket, the bracket may be broken or your bumper is slightly misaligned. Bumper brackets are usually very inexpensive at your local dealership. Once the bumper snaps on, just re-apply the bolts and push pins starting from the tailgate to the wheel wells. You're all done! Source: https://www.revemoto.com Follow Us on FB:   / revemoto   IG:   / revemoto   Twitter: https://twitter.com/revemoto?lang=en ________________________________________________________ #NissanRogue #Nissan #paintedautoparts #Rogue #highquality #DIY #HowTo #revemoto DISCLAIMER: While ReveMoto tries to make the information in this video as accurate as possible, we make no claims, promises, or guarantees about the accuracy, completeness, or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself (DIY) projects entail some risk. It is the sole responsibility of the viewer to assume this risk. ReveMoto is not responsible or liable for any loss, damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.