programmation thermostat stc-1000 (réglage stc1000)

STC 1000 Thermostat Setting. Press and hold S to enter the menu. Press up and down to scroll through F1/F2/F3/F4. Modifies the setting/displays the desired F. Press S + up or down, then press the ON/OFF button. F1: Desired temperature. F2: Tolerance range. F3: Compressor start-up delay. F4: Probe calibration. Use a small dish filled with water and a piece of sponge. Adjust the probe height relative to the bird's height. Another way to adjust the settings F1 = desired temperature Press and hold S: select F1 by moving up or down with the up or down arrows: release S, press S again immediately, the temperature should appear. You can press the up or down arrow (while still holding S) depending on whether you want to lower or raise the desired temperature. Be patient, as the keys are very close together, so select the desired key, lol. F2 = tolerance + or – Press and hold S: select F2 by moving up or down with the up or down arrows: release S, press S again immediately, the tolerance should appear. You can press the up or down arrow (while still holding S) depending on whether you want to lower or raise the desired tolerance. If you want to obtain 32°C and a tolerance of 1°C, you will get 31°C to 33°C, but you will never get a constant 32°C.