Best Impact driver bits | Part 3 | Milwaukee vs Wiha vs Wera vs Bosch vs Dewalt vs Makita

Welcome back to part 3 series on Best Impact Driver bits. If you haven't seen part 1 or 2, watch it here: Part 1:    • Best Impact driver bits | Part 1 | Let's f...   Part 2:    • Best Impact driver bits | Part 2 | Milwauk...   For quality premium impact bits check out the following: WERA kit: https://amzn.to/3deTAXe WERA PH2 only: https://amzn.to/3dbBtS3 Wiha: kit: https://amzn.to/3ecZZUg Wiha PH2 only: https://amzn.to/2N6ckxM May be a little expensive, but as long as you don't lose them, they will most likely last you a lifetime. I don't know about you, but I use an impact driver when ever possible. So bits are important when it comes to transferring that power into the fastener. In this video we are concluding the series in the best impact driver bits. For the test in part 3, we drove 180 griprite 3 inch PH2 exterior screws into 2x4 landscape lumber, and later proceeded toward torture testing the bits until they failed. Failed bit is either physical breakage, or enough damage for constant cam out. For the test we used the Dewalt DCF887, Milwaukee Fuel Gen 3 2853, and Makita XDT14 impact drivers. Bits in the test: Milwaukee Shockwave Gen 1 Milwaukee Matrix Carbide Dewalt Maxfit Makita Gold Impact Bosch Impact Wera Impaktor Wiha terminator Setup and testing of rigs and etc was done by Irwin Impact bit. All the screws and bits used in the test were brand new, and purchased with my own funds at my local hardware store. This video was not sponsored and I am not affiliated with any of these companies. I hope this video was helpful, and we'll see you guys.... NEXT TIME!!! Instagram:   / ak4thewin   Twitter:   / 4thewin8   | 4thewin8 Site: https://www.vlog.4thewin.net/