Project: SV650 GSXR Front End Swap (Lessons Learned)

Links to all the parts (not including the OEM SV650 parts that directly transferred over) I used for the GSXR front end swap: -2006/2007 GSXR 600 fork (purchased used locally) -2006/2007 GSXR 600 triple minus the upper clamp (purchased used locally) -2005/2006 GSXR 1000 upper clamp (purchased used locally) -Aztec8 speedometer mount (www.aztec8.com) -4x 1.75" T-bolt clamps (www.siliconeintakes.com) -SVRP 3.5" riser clip-ons (www.svracingparts.com) -SVRP brake reservoir mount (www.svracingparts.com) -GSXR radial master cylinder (purchased used locally) -CRG RC2 shorty lever for the GSXR radial master cylinder (purchased off ebay) -Galfer SS brake lines with double banjo pre-bent 90 degrees at the master cylinder and measured to fit the GSXR front end with the 3.5" riser clip-ons (www.svracingparts.com) -GSXR radial calipers (purchased used locally) -2006/2007 GSXR front wheel (purchased used locally) -2006/2007 GSXR front fender (purchased used locally) -8x 1/4" rare earth magnets (www.leevalley.com) -8x 1/4" rare earth magnet holders (www.leevalley.com) -8x nuts and bolts to hold the magnets + magnet holders in place (www.leevalley.com) -1" x 3" sheet aluminum bent to hold the hall effect sensor 2-3mm away from the face of the rotating magnets (Home Depot) -Hall effect sensor (Search Cherry hall effect sensor on Ebay) -------------- SVRiders thread on the magnets + hall effect setup: http://www.svrider.com/forum/showthre... Tool for removing the castle nuts that holds the triple tree in place to the frame: http://www.parktool.com/product/crank... Please visit SVRiders.com for anything else you need to know. It is there, trust me. Thanks for watching! Subscribe!