噴射ポンプから燃料漏れしだしたので、社外Oリング・銅パッキンで安く修理する方法を解説いたします！

This time, we'll repair a fuel leak from the holder on top of the injection pump of an engine welding machine (mainly used for generators) used in the factory! This problem is especially prevalent during this cold season... The majority of fuel leaks are caused by a deteriorated O-ring, so we'll repair it with an aftermarket O-ring and copper gasket! However, a shocking truth is revealed midway through the video... This isn't part of the original project, so we won't be doing it this time, but we'll probably do it sometime... What is this shocking truth? So, please watch the video! Note: The tightening torque for the holder is 39.2~44.1Nm {4.0~4.5kgm}. *Warning: Depending on the type of injection pump and how it's handled incorrectly, serious damage or danger may occur. If you are unsure about repair skills, please do not touch it. Please make sure you understand the principles and structure of the machine in detail before proceeding. #engineweldingmachine #enginegenerator #fuelleak