3D-Drucke sind NIE wasserdicht! ODER DOCH?! | Slicer Samstag #18

*3D Printing Academy: https://www.3dd-akademie.de – Become part of the community! *Discount code: Use the code "Lion" and save 10% on your membership permanently! Are 3D prints really never waterproof and do they soak up water like a sponge? 🧽 In this Slicer Saturday, I'll show you the surprising results of my test prints and how you can guarantee your models are waterproof! Discount code: Use code "Lion" and save 10% on your membership! ... ✅ Links from the video 3D Printing Academy: https://www.3dd-akademie.de PETG Filament (recommended): https://de.store.sunlu.com/collection... PLA Filament: https://de.store.sunlu.com/collection... Slicer settings: ⚙️ Normal prints (multiple walls) Wall loops: 3 to 5 Overlap (infill & wall): approx. 25% Top/Bottom Shell layers: 6 to 7 Inner seams: Enable "Offset" 🏺 Vase mode Material recommendation: PETG Printing temperature: Increase by approximately 10 degrees Flow rate: Increase slightly Outer wall thickness: 0.5 mm Bottom (lower shell layers): 8 layers Layer height: 0.16 mm ⏱️ Chapters / Timestamps 00:00 Are 3D prints waterproof? The Rumor & the Surprise 00:21 Welcome to Slicer Saturday & Information about the 3D Printing Academy 01:12 Settings for Waterproof Flower Pots (Normal Prints) 01:55 Wall Grinding, Overlap (Infill/Wall) & Shell Layers 02:46 Making Vase Mode Waterproof: Why the Standard Profile Fails 02:52 Material Selection: PETG vs. PLA & Adjusting Temperature/Flow 03:37 Properly Activating Vase Mode, Adjusting Wall Thickness & Layer Height 04:46 Bonus Tip: Offset Inner Seams for Maximum Sealing 05:53 Summary, Conclusion & Farewell My Equipment 🛒 *My Camera: Sony Alpha ZV-E10: https://amzn.to/420rxre 🛒 *My 2nd Camera: DJI Osmo Pocket 3: https://amzn.to/4r3y137 🛒 *My microphone: DJI Mic Mini: https://amzn.to/4hxctWC 📜 FTC DISCLAIMER: All links or discount codes marked with an asterisk (*) in my video descriptions are affiliate links. This means I receive a small commission on any purchases you make through these links. There are no additional costs for you; it's simply another way to support me and my channel! :-)