How to Change the Drive Belt on a Stihl TS420 Disc Cutter | L&S Engineers

In this video, we show you how to replace the Drive Belt on a Stihl TS420. Click here for a full list of parts, tools & transcript! Parts Genuine Drive Belt for Stihl TS420 https://www.lsengineers.co.uk/genuine... Hexagon Nut M8 for Stihl TS410 TS420 https://www.lsengineers.co.uk/hexagon... Screw IS-D5x20 for Stihl TS410 TS420 https://www.lsengineers.co.uk/screw-i... Tools Genuine Torx Wrench/Plug Spanner for Stihl TS410 TS420 https://www.lsengineers.co.uk/torx-wr... Non Genuine Torx Wrench/Plug Spanner for Stihl TS410 TS420 https://www.lsengineers.co.uk/non-gen... Web: https://www.lsengineers.co.uk/ Facebook:   / lsengineers   Twitter:   / ls_engineers   Blog: https://www.lsengineers.co.uk/blog.html Health & Safety Warning Please ensure that you have safely prepared the machine and workspace. If you are unsure about any aspect of the task please seek professional advice. Transcript Today, we're going to change the drive belt on a Stihl TS420 cut off saw. First of all, use a torx spanner to remove the screw that secures the water connector from the underside of the machine. This will provide better access to the recoil. Next, use a 19mm Hex Socket Spanner, turning it anti-clockwise to loosen the tension of the belt. Once this is done, use a 13mm Hex Socket Spanner to loosen the three nuts that secure the recoil assembly. Then revisit each nut and completely remove them, freeing the recoil from the machine.Using the torx spanner, remove the screw that secures the nose guard to the arm.Once the nose guard is off, use the 19mm Hex Socket Spanner, turning it anti-clockwise to further loosen the tension of the belt. Completely remove the front of the saw to free the belt. If you are unsure whether to replace the belt, inspect it by eye and with your fingers to check for wear & splits in the belt. Bear in mind that the belt may have stretched and the rubber may have lost it's goodness. To fit the replacement belt, locate it over the clutch, making sure the its sitting in the grooves correctly, to prevent damage to the belt. Then feed the belt back through the arm, relocating the arm back in position around the studs. Feed the belt back around the pulley. Slowly turning the pulley will help you easily locate the belt. Make sure the blade turns with a smooth motion. Relocate the casing onto the arm and use the torx spanner to fix this in place. Make sure the screw is secure without over tightening it, as the casing is only plastic. Locate the recoil assembly onto the machine, loosely turn each nut a few times.Then return to tighten each nut with the 13mm spanner, again, be careful not to split the plastic when tightening. Then re-tension of the belt using the 19mm Hex Socket Spanner. Don't forget to fix the water connector back into place under the machine using the torx spanner.That's how you change the drive belt on the Stihl TS420. All the parts & tools needed for this task are listed in the description below. If you have any issues, questions or would like to talk to our customer service team please visit our website. Please note L&S is a UK based trading company, please see our website for information on delivery to other countries.