2005 Honda Pilot Exhaust Gas Recirculation (EGR) Valve Cleaning

After a few failed attempts to fix my Honda's rough idle condition with the PCV Valve and the MAP Sensor, I finally solved the mystery with the EGR Valve cleaning. This was a very easy job to do, and only required a 12mm socket, a lot of carburetor cleaner and a new EGR Valve Gasket. Tools and Equipment Used: Vinyl Gloves - https://amzn.to/3laLR0A 12 mm Socket 3/8 Drive - https://amzn.to/3o5pEmA Honda EGR Valve Gasket - https://amzn.to/2HLdUWE Carb Cleaner - https://amzn.to/33pV1QV Scotch Brite Pads - https://amzn.to/3ml8W1O Needle Nose Pliers - https://amzn.to/2JrU2YY 3/8 inch Drive Torque Wrench - https://amzn.to/3mgshS0 Socket Extension 3/8 - https://amzn.to/3mhjGhZ As an Amazon Associate I earn from qualifying purchases. Disclaimer: Due to factors beyond the control of DIYNorth, DIYNorth cannot guarantee against improper use or unauthorized modifications of this information. DIYNorth assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. DIYNorth recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of DIYNorth, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not DIYNorth.